| Step 1: Tape one end of the Soft Flex wire, leaving a tail of about 3". The tape will keep your beads from slipping off the wire. |
 |
| Step 2: Start stringing your beads on the Soft Flex. When you have strung the amount desired, string a crimp bead on the wire. |
 |
| Step 3: String the Soft Flex through the loop on your clasp and bring it back around through the crimp bead and through several of the beads that follow. |
 |
| Step 4: Pull the end of the Soft Flex with your fingers until it is drawn up to form a small loop between the crimp bead and the clasp. With chain nose pliers, flatten the crimp bead so that the Soft flex is held firmly in place. |
 |
| Step 5: With a wire cutter, clip the excess wire and repeat steps 3 and 4 on the other side of the strung beads. Make sure you remove the tape and pull up any slack. |
 |
